Dent Auto Body Repair - Development of a repair plan

Developing a repair plan In this article, we will examine how to remove a tooth part of the automobile. We determined that the panel is made of mild steel and compensation for damage would be a better choice than replacing the board. Now we have to develop a repair plan and decide what repair method to use on the damage. First In Last Out The first thing you want to determine is the direction of damage. This is important so that you can reverse the damage during repairs. Collide, we have a general rule, "the first in the last of the rule." This means that any direct or point the impact is the first area affected in an accident, making it the first. Therefore, this should be the final repair. Direct damage is the most obvious damage as it is easy to see visually. If you try to make the first direct, stretch metal, draw peaks in the metal, and even lower. You are basically going to hunt around your damage while metal hardening work until the metal become hardened to work, breaking and cracking. and indirect Indirect damage is the damage that is caused by direct damage. For example, as the point of impact is pushed, it causes the surrounding metal to also move slightly. If pushed far enough, indirect damage can cause deficiencies misalignment of the body seam sealing cracks, and / or popped welds. Indirect damage is less noticeable because it can not be visually substantially without close supervision. Indirect damage is damage that last happened during the accident, therefore, that damage must first repair. Always remember the rule "first in last out" developing a repair plan. This will save you hours of time and frustration when it is done. Choice a repair method Once the damage is analyzed and you have determined the direction of the damage, and the direct and indirect damages. Now it's time to decide what repair method is the best choice for repair. If you can get on both sides of the panel method of hammer and dolly may be the easiest method of repair. If you can not access both sides of the panel of a stud-nail gun can be a better choice. Other considerations, such as protection against corrosion and noise impediments must be taken into account. This will be covered at a later date. Do not force the metal, but rather Roll The metal back to its form Whatever the method of repair, the same principles apply. Start with indirect and pull the bottom and push the peaks. You have to roll the metal form, rather than trying to force it back into shape. Force the metal back into shape can lead to ups and stretched metals. condition. Pulling the bottom while rolling peaks on metal is the key metal straightening, regardless of the repair method used.

Tweet